Artikla trenutno ni na zalogi. Spodaj se lahko prijavite in poslali vam bomo obvestilo, takoj ko artikel prispe na zalogo. Obvestilo boste dobili samo za ta artikel.
This is the assembled version of the Pi T-Cobbler Plus. It only works with the Raspberry Pi Model A+/B+/Pi 2/Pi 3!
The Raspberry Pi B+, Pi 2 and Pi 3 have landed on the Maker World like a 40-GPIO pinned, quad-USB ported, credit card sized bomb of DIY joy. And while you can use most of our great Model B accessories by hooking up our downgrade cable, its probably a good time to upgrade your set up and accessorize using all of the Model B+'s, Pi 2's and Pi 3's 40 pins.
The T-Cobbler Plus is an add on prototyping board from Adafruit specifically designed for the B+, Pi 2 and Pi 3 that can break out all those tasty power, GPIO, I2C and SPI pins from the 40-pin header onto a solderless breadboard. This set will make "cobbling together" prototypes with the Pi super easy.
Each order comes with a 40 pin ribbon cable and assembled T-Cobbler Plus. You can plug the 40-pin GPIO cable between the Pi computer and the T-Cobbler breakout. The T-Cobbler can plug into any solderless breadboard (or even a prototyping board like the PermaProto). The T-Cobbler PCB has all the pins labeled nicely so you can go forth and build circuits without keeping a pin-out printout at your desk.
Designed for use with Raspberry Pi Model A+/B+/Pi 2/Pi 3 only. No soldering required!
The Raspberry Pi B+ / Pi 2 / Pi 3, solderless breadboard, breadboarding wires, cables, components, power supply, etc are not included! We do stock many of those items in the shop, so check those out as well!
Note: The Raspberry Pi Model A+ and Model Pi 2 are also compatible with this product!
73mm x 20mm x 11mm / 2.9" x 0.8" x 0.4"
Height with pins: 19mm / 0.8"
Width at top of T: 58mm / 2.3"