Artikla trenutno ni na zalogi. Spodaj se lahko prijavite in poslali vam bomo obvestilo, takoj ko artikel prispe na zalogo. Obvestilo boste dobili samo za ta artikel.
Gertbot Motor Control Board for Raspberry Pi
The Gertbot is a an add-on board made especially for, and compatible with all versions of the Raspberry Pi. By plugging the Gertbot to your Pi's GPIO header, you are able to control and drive a variety of motors such as stepper and brushed motors. The Gertbot can also be used as a stand-alone board and can be controlled from any computer via a UART serial port.
•64 MHz ARM Cortex-M3 processor
•Can drive 30 V and 2.5 A
•Easy to set up
•High level commands make it easy to control
•Capacity to plug in up to 4 more boards
•Outputs are short-circuit and thermal protected
•The board can be controlled without programming